컨텐츠 바로가기


  • 현재 위치

    1. 게시판
    2. Reference

    Reference

    Reference입니다.

    게시판 상세
    제목 Scalextric Subaru Challenge
    작성자 영일교육시스템 (ip:)
    • 작성일 2015-12-10 17:56:59
    • 추천 추천하기
    • 조회수 1224
    • 평점 0점

            

    Subaru Impreza RS

    Introduction

    Subaru Impreza RS

    The Subaru Impreza is a World Champion car with the following specifications:

    • Engine: 2.5L Horizontally opposed SOHC, 16 Valve four
    • Configuration: 4 Wheel drive
    • 0 to 60 mph: 8.3 seconds
    • Top speed: 125 mph
    • Power: 165 hp @ 5,600 rpm
    • Length: 172.2 inches
    • Width: 67.1 inches
    • Height : 55.5 inches
    • Fuel economy: 22/29 mpg (city rating)

    The aim of the experiment is to measure and record the speed of the car with an ADC-11. Due to budget limitations purchasing the above Subaru Impreza RS was out of the question. The only alternative was to go for the next best thing:

    Scalextric logo



    Equipment required

    The Subaru challenge box set was purchased, set up and tested. After a few days of testing it was decided that the technical staff should stop playing with it and actually perform a data logging experiment. The following equipment was used:

    • PC with PicoScope installed
    • ADC-11 multi channel data logger
    • ADC-11 Terminal block
    • Scalextric Subaru Challenge
    • EL031 Light sensor
    • High intensity LED
    • Magnifying glass
    • 100 k resistor
    • 1 k resistor





    Experiment setup

    The equipment was set up so that the cars will break the light being received by the EL031 light sensor, thus affecting the resistance and causing a larger voltage drop across it.

    Subaru Scalextric experiment equipment

    Equipment

    Subaru Scalextric Experiment circuit

    Circuit diagram


    Note that the digital output (DO) from the ADC-11 is used to power the LED and provide the voltage across the EL031. The light sensor was setup so that it was directly in the line of the LED. It was found that better results were achieved when the light emitted from the LED was focused with the aid of a magnifying glass.The track itself was setup as an oval, with the following parts:

    Subaru Scalextric Experiment track setup

    The track

    Subaru Scalextric Experiment - the equipment

    The equipment

    It would not be fair to race cars using the above sections as no cross over sections are employed so the distances that the cars have to travel to complete a lap has a difference of over half a metre. The table below shows the track used:

     

    LanesStraightStraight QtyCurveCurve QtyTotal distance
    Inside0.3560.2083.7 Metres
    Outside0.3560.26584.22 Metres

    첨부파일
    비밀번호 * 삭제하려면 비밀번호를 입력하세요.
    관리자게시 스팸신고 스팸해제
    목록 삭제 수정 답변
    댓글 수정

    비밀번호

    수정 취소

    / byte



  •